PIC32MX250F128C-I/TL

Introduction

The PIC32MX250F128C-I/TL belongs to the category of microcontrollers and is widely used in various electronic devices. This entry provides an overview of its basic information, specifications, detailed pin configuration, functional features, advantages and disadvantages, working principles, application field plans, and alternative models.

Basic Information Overview

• Category: Microcontroller
• Use: Embedded control applications, consumer electronics, industrial control systems
• Characteristics: High performance, low power consumption, integrated peripherals
• Package: 28-pin TQFP
• Essence: Advanced microcontroller with enhanced features
• Packaging/Quantity: Tape and reel, 2500 units per reel

Specifications

• Processor: 32-bit MIPS core
• Flash Memory: 128 KB
• RAM: 32 KB
• Operating Voltage: 2.3V to 3.6V
• I/O Pins: 23
• Timers: 5 x 16-bit, 1 x 32-bit
• Communication Interfaces: SPI, I2C, UART
• Analog-to-Digital Converter (ADC): 10-bit, 15 channels
• Clock Speed: Up to 50 MHz
• Operating Temperature: -40°C to 85°C

Detailed Pin Configuration

The PIC32MX250F128C-I/TL features a 28-pin TQFP package with specific pin configurations for power, I/O, communication, and other functions. Refer to the datasheet for the detailed pinout diagram.

Functional Features

• High Performance: 32-bit MIPS core enables fast processing
• Low Power Consumption: Ideal for battery-powered applications
• Integrated Peripherals: Rich set of peripherals for diverse applications
• Flexible Communication Interfaces: Supports SPI, I2C, and UART for connectivity
• Analog-to-Digital Conversion: 10-bit ADC for analog sensor interfacing

Advantages and Disadvantages

Advantages

• High processing power
• Low power consumption
• Integrated peripherals reduce external component count

Disadvantages

• Limited RAM compared to some competing models
• Higher cost compared to lower-end microcontrollers

Working Principles

The PIC32MX250F128C-I/TL operates based on the 32-bit MIPS core architecture, executing instructions at high speed while consuming minimal power. It interfaces with external components through its I/O pins and communication interfaces, enabling control and data exchange in embedded systems.

Detailed Application Field Plans

The PIC32MX250F128C-I/TL is suitable for a wide range of applications including: - Consumer Electronics: Smart home devices, wearable gadgets - Industrial Control Systems: Factory automation, motor control - Automotive Electronics: Engine control, dashboard displays - Medical Devices: Patient monitoring, diagnostic equipment

Detailed and Complete Alternative Models

• PIC32MX150F128C-I/TL: Similar features with reduced flash memory
• PIC32MX250F256D-I/TL: Higher flash memory capacity and additional peripherals
• PIC32MX450F256H-I/TL: Enhanced peripherals and extended operating temperature range

In conclusion, the PIC32MX250F128C-I/TL is a versatile microcontroller with advanced features suitable for various embedded control applications. Its high performance, low power consumption, and integrated peripherals make it a compelling choice for designers seeking reliable microcontroller solutions.

Word Count: 498