Power chip

The CAT3200HU2 is a switched capacitor boost converter that provides a low noise, regulated output voltage. The CAT3200HU2 provides a fixed regulated 5 V output when the FB pin is grounded, otherwise an adjustable output using an external resistor. A 2 MHz constant frequency charge pump allows the use of small 1 µF ceramic capacitors. The device can support up to 100 mA maximum output load over a wide input supply voltage range for battery powered applications. A shutdown control input allows the device to be placed in power-down mode, reducing supply current to less than 1 µA. In the event of a short circuit or overload condition, the device is fully protected by current limiting and thermal overload detection. Additionally, soft-start, slew-rate control circuitry limits inrush current during power-up.

Vout=-5V

Output current: 200ma Input voltage: 5.25V Number of output groups: 1 Output voltage: 5V

Input Voltage: 21.6-26.4Vdc\nOutput Voltage: 5V\nOutput Current: 0.4A\nOutput Power: 2W\nIsolation Voltage: 1500VDC\nConversion Efficiency: 90%\nFeature: Output Short Circuit Protection

-

-

The FSBB10CH120DF is an advanced power module for motion control, providing a full-featured, high-performance inverter output stage for AC direct induction, BLDC and PMSM motors. The modules integrate optimized gate drive for the built-in IGBTs to minimize EMI and losses, while also providing several on-module protection features including undervoltage lockout, overcurrent shutdown, high temperature monitoring of the driver IC, and fault reporting. Requiring only one supply voltage, the built-in high-speed HVIC converts incoming logic-level gate inputs into the high-voltage, high-current drive signals required to properly drive the module's internal IGBTs. Each phase has separate negative IGBT terminals to support the widest range of control algorithms.

TPS2421-1 20V, 5A, 33mΩ eFuse with PG