Power chip

DIP: 38*19*18mm, output 5V, 5W, accuracy 1%, output ripple measured 50mV with aluminum capacitor less than 30mV, withstand voltage greater than 2.5KVAC, industrial grade, the efficiency of this series is as high as 80%, and the standby power consumption is as low as 0.1W, standard size compatible with multi-manufacturer pins.

The NCV7708F is a fully protected six-way half-bridge driver, especially suitable for automotive and industrial motion control applications. The six high-side and low-side drivers are freely configurable and individually controllable. Thus high side, low side and H-bridge control can be achieved. H-bridge control provides forward, reverse, brake and high impedance states. The driver is controlled through a standard SPI interface.

LM2595 SIMPLE SWITCHER POWER CONVERTER 150 KHz 1A BUCK VOLTAGE REGULATOR

Power 5W Input Voltage Range 85-264Vac\n100-370Vdc Output Voltage/Current (Vo/lo) 12V/0.41A Efficiency% 75

-

Dimensions: length 39.0*width 25.0*height 21.0mm; with over-current, over-temperature and short-circuit protection function, moisture-proof, dust-proof and high-temperature resistance

The FNA25060 is a Motion SPM 2 module that provides a full-featured, high-performance inverter output stage for AC direct sense, BLDC and PMSM motors. These modules integrate optimized gate drive of the built-in IGBTs to minimize EMI and losses, while also providing several on-module protection features: undervoltage lockout, overcurrent shutdown, temperature sensing, and fault reporting. Requiring only one supply voltage, the built-in high-speed HVIC converts incoming logic-level gate inputs into the high-voltage, high-current drive signals required to properly drive the module's internal IGBTs. Separate negative IGBT terminals are provided for each phase to support the widest range of control algorithms.

-

Motor Drive with Hall Sensors

Vout=1.5V